Chapter 2 BIOS Setup
2-30
CPU Clock Ratio
This item allows you to select the CPU Ratio.
If unfortunately, the system’s frequency that you are selected is
not functioning, there are two methods of booting-up the
system.
Method 1: Clear the COMS data by setting the JCOMS1 ((2-3) closed))
as “ON” status. All the CMOS data will be loaded as
defaults setting.
Method 2: Press the <Insert> key and Power button simultaneously,
after that keep-on pressing the <Insert> key until the
power-on screen showed. This action will boot-up the
system according to FSB of the processor.
※
It’s strongly recommended to set CPU Vcore and clock in
default setting. If the CPU Vcore and clock are not in default
setting, it may cause CPU or M/B damage.
To Next Page
Loading...
