146
6 Message Prompts and
Troubleshooting
6.1 Message Prompts
Trig level at limit! : Prompts you that the trigger Level is at a limit
when you turn the Trig level knob.
Horizon position at limit! : Prompts you that the horizontal
position is at a limit when you turn the horizontal position knob.
Volts/Div at limit! : Prompts you that the vertical voltage has
already reached the Min 2mV/div or the Max 5V/div.
Volts position at limit! : The system would display this
information when the vertical position is at a limit.
Sec/Div at limit! : Prompts that the Time/Div is at full range while
turning the horizontal scale knob.
Holdoff time at limit! : Prompts you that the holdoff time setting
has reached max or min value.
Function isn’t useable! : Under several special modes, some
functions could not be running.
No signal! : The system would display this information when the
signal could not match the auto set condition while using the
auto set function.
Adjust at limit! : Prompts that the pulse width setting has
reached min 20.0 ns or max 10.0 s.
Location Empty! : If you have no stored waveforms or setups at
specified location, the screen will display this information when
you press the “Recall” button on this location.
USB Flash Drive Plug In! : This information will appear when you
insert the USB Flash Drive to the USB Host port.
USB Flash Drive Pull Out! : This information will appear when you
pull out the USB Flash Drive from the USB Host port.
Store Data Success! : Saving setup data, waveform data or
picture data to the internal memory of the oscilloscope or USB
flash was successful.
Read Data Success! : Read setup data or waveform data from the
internal memory of the oscilloscope or USB flash was successful.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
