19
saved settings from that location. If the selected memory location does not have any
saved settings, the message Recall Data Empty! will be displayed.
Note: When in Recall mode, users can recall settings from different locations without
having
to press additional keys each time. For example, you can press 1 to recall settings
in location 1, and then press 5 to immediately recall settings in location 5.
3. To exit Recall mode at any time, press the button again or press .
3.7 Key Lock
The front panel keys can be locked to prevent unwanted changes to output settings and power
supply configurations. Follow the steps below to enable/disable key lock.
1. Press the key and the button. A Lock indicator will light up on the
display, indicating that the front panel keys are locked. At this point, all keys are disabled
except for the key, button and button.
2. To unlock the keys, press the key and button again. The Lock indicator
will disappear and all keys will be enabled.
3.8 Output Check
Voltage Check
Follow the steps below to check the voltage output with no load connected.
1. Turn on the power supply. The display should look like the following.
Figure 10 - Voltage Check
2. Enable the output by pressing ; the button will illuminate. The < >will be
replaced with a numeric value and a next to this value for each channel.
3. Press the button if it is illuminated to enter the settings mode.
4. Press first, and then a numeric value on the keypad and then press the
button.
Note: The button will automatically return to meter mode and illuminate after
5 seconds of a valid entry (see 4.10 Return Meter to disable this).
www.GlobalTestSupply.com
Quality BK Precision Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
