Appendices
724-746-5500 | blackbox.com
Page 63
To create a new host entry
1 Click one of the host entries to reveal a Host configuration dialog.
Name
Enter the name that will be displayed in the viewer window when you click the Host button.
Users
Select the users that will be permitted to connect to this host. Either enter
*
to allow all users or a list of users separated by
commas.
KVM Switch Macro
Declare the hot key sequence that will cause the KVM switch to link with the required host system.
Hotkey Host Number
Declare the numeric sequence that is pressed together with the VNC viewer hotkeys (usually Ctrl + Alt) to select this host
system, which is the same value as the KVM port number.
Power On
Enter the code required to make an attached power control unit apply power to the host. See Power switching configu-
ration for details.
Power Off
Enter the code required to make an attached power control unit remove power from the selected host.
Reboot
Enter the code required to make an attached power control unit remove power and then re-apply it a few seconds later.
2 Enter the required information in each field.
3 Click the OK button.
To Next Page
Loading...
Need help?
General