Page 197
724-746-5500 | blackbox.com
Chapter 5: Operation
Figure 5-10. Menu—CON Switch.
To switch to a local source, proceed as follows:
1. If you are not yet in the Switch menu of the OSD, start Command Mode with
the hotkey (see Chapter 5.1, Page 53).
2. Press <o> to open OSD.
You will see a list of all available CPUs in the menu.
3. Switch to the CPU in the list that is called Local CPU.
The switching operation to the local source will be immediately performed.
NOTE: The local source (computer, CPU) will be only shown in the OSD if the
respective CON Unit includes the option for a local connection.
To Next Page
Loading...
