Black Box ServSwitch DKM FX - 4 Configuration; Command Mode

Page 80
724-746-5500 | blackbox.com
Chapter 4: Configuration
4. Configuration
4.1 Command Mode
The ServSwitch DKM FX has a Command Mode that enables several functions via
keyboard command during normal use.
To enter Command Mode, use a hotkey sequence, and to exit Command Mode,
press <Esc>. While in Command Mode, the Shift and Scroll LEDs on the console
keyboard will flash.
NOTE: In Command Mode, normal keyboard and mouse operation will cease.
Only selected keyboard commands are available.
NOTE: If there is no keyboard command executed within 10 seconds after
activating Command Mode, it willl be automatically deactivated.
The following table lists the keyboard commands to enter/exit Command Mode
and to change the hotkey sequence:
Table 4-1. Command mode components.
Function Keyboard command
Enter Command Mode (default) 2x <Left-Shift> (or hotkey)
Exit Command Mode <Esc>
Change hotkey sequence
<hotkey>, <c>, <new hotkey code>, <Enter>
Earlier versions of firmware (before 9/30/2011):
<Left Ctrl> + Left Shift> + <c>, <hotkey Code>, <Enter>
NOTE: <Key> + <Key> = Press keys simultaneously; <Key>, <Key> = Press keys
successively, 2x <Key> = Press key quickly, twice in a row (similar to a
mouse double-click).