To Next Page

To Previous Page

Camera Video Output

Connect the camera's SDI output to the HyperDeck's SDI

input and connect the HyperDeck's SDI output to the

camera's SDI input to view your recordings.

+12V POWER HDMI IN HDMI OUT SDI IN SDI OUT

Connecting to Video Switchers

Blackmagic Studio Cameras output 10-bit 4:2:2 video so you can connect to broadcast switchers and

other SDI video equipment. Optical input and output means ATEM Camera Converters are not required

at the camera end.

You can easily view the Program (PGM) output from the switcher by connecting it to your Studio Camera's

SDI or optical fiber input.

Blackmagic Studio Camera also features a reference input which allows multiple cameras to be genlocked

to a blackburst or tri-level reference signal. Genlocking cameras, VTRs and other devices to an external

reference signal helps to eliminate timing errors which may result in the picture jumping when switching

between different sources.

Connecting to Recorders

If you simply wish to record your Studio Camera's output, you can connect the SDI output to the SDI input

of an SSD recorder such as the Blackmagic HyperDeck Shuttle. The SDI output from the HyperDeck can

then be connected to the Studio Camera's SDI input, so you can view your recordings on the camera's LCD.

Connect either SDI or optical cables from your Studio Camera

to a production switcher or other device.

OPTICAL OUT

OPTICAL IN

SDI OUT

SDI IN

REF

12V