CONTROL PANEL MENU FUNCTIONS (MODEL DEPENDENT)
The menu functions on the Controller’s Control Panel allow you to operate
various motors, quickly switch off loads and pair or clear the Node.
The following functions apply depending on what is available in your RV.
Awnings
Navigate to the desired awning:
A1 (Awning 1)
A2 (Awning 2)
then press EXT or RET to operate.
Slide-outs
Navigate to the desired slide-out:
S1 (Slide-out 1)
S2 (Slide-out 2)
S3 (Slide-out 3)
S4 (Slide-out 4)
S5 (Slide-out 5)
S6 (Slide-out 6)
then press EXT or RET to operate.
Pairing
To pair the Node with the Controller, your
own smartphone, or to clear the Node of
any pairings.
For more information, see Pairing to the
Node with a Controller and FAQs and
Troubleshooting.
Off (Model Dependent)
Navigate to OF, then press EXT to turn
power OFF to all appliances.
The OF function will not shutdown
generators connected to the Node.
Navigate to the OF function, then
press EXT to confirm that power to all
accessories should be turned off.
NOTE: The Controller will turn off after
10 seconds. The Controller can be turned
back on by pressing any of the Light
buttons on the Control Panel.
Ramp Door
Navigate to the desired ramp door, then
press EXT or RET to operate.
Jacks
Navigate to the desired Jack:
J1 (Landing Jack)
J2 (Front Stabilizing Jack)
J3 (Rear Stabilizing Jack)
then press EXT or RET to operate.
15
To Next Page
Loading...
Need help?
General