PAIRING TO THE NODE WITH A CONTROLLER (MODEL DEPENDENT)
Pairing your Controller, smartphone or tablet to the Node is done in three easy
steps. The App will guide you through the pairing process.
NOTE: The Controller will have been paired to your Node at the factory. You
should only need to pair your own device or smartphone to the Node.
While the Node can be paired to a total of four devices (including the Controller),
you can only pair one device at a time to the Node.
1. Launch the App on your phone.
2. Using the < or > buttons on the Controller, navigate to the PA menu item.
3. When ‘PA’ appears on the display, press the EXT button to start the pairing
process to the Node. ‘PA’ will blink for a maximum of 30 seconds or until a
device is connected.
WARNING
Only press the EXT button once, do not hold the button down. Holding the button down
for too long may cause all devices to unpair from the Node.
17
To Next Page
Loading...
Need help?
General