FAQS AND TROUBLESHOOTING
PAIRING WITH THE NODE
I tried pairing my phone to the Node, but it didn’t connect?
If pairing fails, before you attempt to pair your smartphone again:
1. Toggle the smartphone’s Bluetooth off and on.
2. Toggle the smartphone’s Airplane mode on and off.
3. Restart the App.
4. Cycle power to the Node off and on.
I tried pairing my phone to the Node but the Display failed?
If your system has a Display, and the Display failed when pairing with the Node,
this indicates the Node is already paired to four devices and cannot support any
more devices.
In this case, unpair one of the connected devices and try again.
Alternatively, clear all previously paired devices and pair your smartphone and
the Display again.
I tried pairing my phone to the Node but the Controller displays --?
If your system has a Controller, and the Controller displays -- when pairing with
the Node, this indicates the Node is already paired to four devices and cannot
support any more devices.
In this case, unpair one of the connected devices and try again.
Alternatively, clear all previously paired devices and pair your smartphone and
the Controller again.
How do I unpair the Node from my device?
1. From the App home screen, press the Settings icon
.
2. Press Bluetooth Connection.
3. Press Unpair RV.
If you have a Controller installed in your RV, you can also clear the Node’s memory
of all paired devices.
WARNING
Clearing the Node memory will also clear the pairing between the Node and
Controller. After clearing, the Controller will need to be paired to the Node again.
54
To Next Page
Loading...
Need help?
General