SWITCH (MODEL DEPENDENT)
I’ve replaced the Switch in my RV, but it doesn’t work?
You may need to pair the Switch to the Node before you can use the Switch.
The instructions are different depending on if you have a Display or a Controller
as part of your system.
If you have a Display:
1. Using the
button on the Display, navigate to the Settings menu.
2. Using the
button on the Display, navigate down to Advanced.
3. In the Advanced setting menu, use the
button to navigate down to Pair
Switch.
4. Press the OK action button to put the node into Switch pairing mode.
5. While in paring mode, press any TWO buttons at the SAME TIME on the switch
you want to pair.
If you have a Controller:
1. Using the < > buttons on the Controller, navigate to the PA menu item.
The Controller is displaying the code 88 and is unusable, what do I do?
The Controller will display 88 on its menu display if there is a system error which
prevents the use of the system.
If you encounter an 88 error, please contact your RV dealership for further
assistance.
2. When ‘PA’ appears on the display, press the RET button to start the pairing
process between the Switch and the Node.
3. Press any two buttons on the Switch at the same time.
4. Press EXT on the Controller to accept the pairing of the Switch to the Node.
56
To Next Page
Loading...