AUTOMATIC GENERATOR START
You can keep your battery and climate levels steady by using Automatic Generator
Start (AGS).
AGS will keep your levels steady by automatically turning your generator on or off.
To use AGS, you may need to update the App on your smartphone.
If AGS is enabled, the App will attempt to start the generator a total of four times
to try and keep levels steady.
If there are four failed starts, the App will stop attempting to start the generator.
If the generator fails to start, please consult your generator’s owner’s manual.
Generator Fault
If the Generator Status section in the App indicates a fault:
1. Press the Stop Generator button.
2. Fix the fault with the generator.
3. Press the Start Generator button.
If the fault has been fixed, when you next turn the generator on from the App, the
Generator Status section will display “No fault”.
Generator Lockout (Model Dependent)
The generator will be automatically locked out if a high input is detected on the
brakes. This will be shown on the Node at pin 64.
The generator cannot be turned back on until the lockout is disabled.
The App will not show a pop-up if the generator is locked out.
The lockout can be disabled by:
9 Using the redundancy switches on the Controller.
9 Sending leveling commands with the leveller.
35
To Next Page
Loading...
Need help?
General