SWITCH (MODEL DEPENDENT)
The Switch communicates via Bluetooth to the Node, giving you additional control
of RV features.
NOTE: Any Switch you install in your RV has been paired to the Node at the factory
and is ready for immediate use. If a Switch isn’t responding, it may need to be re-
paired. Refer to FAQs and Troubleshooting for more information.
CHECKING THE BATTERY IN YOUR SWITCH
The Switch is powered by a standard CR2032 3V Lithium Cell coin battery.
To check if the battery needs replacing:
1. From the App home screen, press the Settings icon
2. Press Battery Levels.
3. Press any button on the Switch you are checking.
Once the button has been pressed, the App will refresh with the Switch battery
status.
LOW indicates the battery in the wall switch needs replacing.
REPLACING THE BATTERY IN YOUR SWITCH
To replace the battery, unclip the Switch Button
Pad. Using a flathead screwdriver, pry open the
Switch Button Pad and remove the battery from the
holder. Insert the new battery in the holder with the
positive side facing up.
53
To Next Page
Loading...
Need help?
General