can be recharged via the 12V
power socket.
Switch off operational readi-
ness ( 38).
Removing side panel ( 98).
Charge the 12V battery using
a suitable charger. In this pro-
cess, comply with the operat-
ing instructions of the charger.
The 12V battery has to be
recharged at regular inter-
vals in the course of a lengthy
period of disuse. See the in-
structions for caring for your 12V
battery. Always fully recharge the
12V battery before restoring it to
use.
Installing side panel ( 99).
Replacing 12V battery
with anti-theft alarm (DWA)
OE
If applicable, switch off the anti-
theft alarm.
Switch off operational readi-
ness.
Removing side panel ( 98).
Disconnection in the wrong
sequence increases the risk
of short-circuits.
Always proceed in the correct
sequence.
Disconnect the negative bat-
tery cable and remove screw 1.
Disconnect the positive battery
cable and remove screw 2.
Remove screw 3 and remove
the retainer.
Remove the 12V battery from
the battery holder.
Slip the 12V battery into the
battery holder.
Position the retainer on the
12V battery.
Install screw 3.
Installation in the wrong
sequence increases the risk
of short-circuits.
Always proceed in the correct
sequence.
Hold the positive battery cable
in position and install screw 2.
9
101
z
Maintenance
To Next Page
Loading...
