In order to ensure the dependab-
ility of the brake system, do not
permit the brake pads to wear
past the minimum permissible
thickness.
Have the brake pads
replaced by an authorised
BMW Motorrad dealer.
Check rear brake pad
thickness
Make sure the ground is level
and firm and place the E-
Scooter on its stand.
Visually inspect the brake pads
to ascertain their thickness.
Viewing direction: from the
bottom right toward brake
pads 1.
Brake-pad wear limit,
rear
min 1.0 mm (Friction pad only,
without backing plate.)
If the brake pads are worn past
the minimum permissible thick-
ness:
If the brake pads are per-
mitted to wear past the
minimum permissible thickness
braking performance is reduced
and there is the possibility of the
E-Scooter moving even with the
side stand extended.
In order to avoid the risk of the
E-Scooter toppling off its stand,
do not permit the brake pads to
wear past the specified minimum
thickness.
Have the brake pads
replaced by an authorised
BMW Motorrad dealer.
Checking brake-pad
thickness, parking brake
Make sure the ground is level
and firm and place the E-
Scooter on its stand.
9
90
z
Maintenance
To Next Page
Loading...
