1.0 Introduction
The BOCA Lemur-FDIO is a direct thermal flight strip printer. This device is capable of connecting to
the FAA host computer, printing, cutting and stacking Domestic and Oceanic flight strips. This manual
will provide the user with general information regarding printer set-up, operational instructions and
detailed technical information. Please see the Programming Guide for information related to interface
protocol along with special features for the FDIO application.
2.0 Unpacking the Printer
The printer is shipped in a ruggedized container. Please save packing material for future use.
Remove the printer and accessories from the box and inspect for obvious damage. If damage is
noticed, please report it immediately to BOCA. Email: cathy@bocasystems.com Tel: (561) 998-9600
Fax: (561) 998-9609
The following items should be in the box:
a) Lemur- FDIO printer
b) Hopper (output)
c) Hopper (input)
d) AC cable
With top box removed
To Next Page
Loading...
