Operation
BOMAG38 BMP 8500
Stopping the machine
Fig. 41
l Travel lever (Fig. 41) in middle position. The
machine will brake.
Steering the machine
Fig. 42
l Actuate the travel levers (Fig. 42) accordingly.
Straight ahead = Steering lever in middle posi-
tion
To drive to the
right = Move the travel lever to the
right
To drive to the
left = Move the travel lever to the left
Cleaning after use
Keep the cable remote control clean.
Rests of concrete, clay or mortar may damage
the bellows on travel levers and sealing caps
on toggle switches, so that water can enter.
Do not use a water jet or a high pressure or
steam cleaner for cleaning.
l After work clean the cable remote control with
a clean cloth or brush.
l Check the state of bellows and sealing caps at
regular intervals, have replaced by an expert,
if necessary.
To Next Page