Bomag BMP 8500 - Starting Operation of the Radio Remote Control; Inserting the Replacement Power Pack; Switching on the Transmitter

Operation
BOMAG 43BMP 8500
4.10 Starting operation of the ra-
dio remote control
!
Danger
The minimum distance between operator and
machine must be 2 m.
!
Caution
Use the transmitter only if the type approval
has been granted.
Fig. 57
l Set the toggle switch (Fig. 57) to remote con-
trol position.
Inserting the replacement power pack
!
Caution
Change the power pack only when the sender
is switched off.
Fig. 58
l Turn the ignition switch to position "0" (Fig. 58)
and pull it off.
Fig. 59
l Insert the replacement power pack into the re-
ceptacle (Fig. 59) and let it click into place.
i
Note
Make sure the power pack clicks into place.
Duty time with a fully charged power pack:
approx. 100 hours
Switching on the transmitter
!
Danger
Life hazard!
In order to avoid unauthorized operation of the
machine do not leave the activated transmitter
unattended.
Operate the transmitter only if the machine is
in your field of vision.