Bomag BMP 8500 - Teaching the BOSS Safety System Transponder

Operation
BOMAG52 BMP 8500
4.16 Teaching the BOSS safety
system transponder
When replacing a defective remote control only
units with a completely black housing must be
used. Please follow the described procedure when
installing new components of the radio system or
the safety system (BOSS):
l Shut down the engine,
l switch off the main battery switch,
l replace defective components,
l switch on the main battery switch,
l plug the spiral cable into the remote control.
Fig. 82
l Turn the tumbler switch for the cable remote
control to position "Left", cable operation (Fig.
82).
Fig. 83
l Turn the ignition switch to position I (Fig. 83),
charge control lamp and oil pressure control
lamp come on.
l Move the remote control out of the safety field.
l The safety field control lamp goes out at the
latest after 2 seconds.
The machine is now ready for operation.