Trouble shooting
BOMAG98 BMP 8500
Engine over-
heating, engine
must be shut
down immedi-
ately!
Cooling fins heavily soiled Clean the cooling fins
Injection valve defective Have examined by a specialist
Engine oil level too high Drain the oil down to the top dipstick mark
Injection pump displacement not correctly
adjusted
Have corrected by a specialist
Lack of cooling air Remove any clogging from the cooling air
duct
Engine has too
low oil pressure,
engine must be
immediately
shut down!
Leaks in the lubrication system, oil level
too low
Check fittings on oil lines and lubrication
oil filter for leaks, if necessary tighten all
fittings Fill up engine oil up to the mark on
the dipstick
Engine oil with wrong SAE viscosity class Change the engine oil
Charge control
light lights up
during operation
The generator does not charge the bat-
tery, because of defect on generator or
regular
Have examined by a specialist
Fault Possible cause Remedy
To Next Page