Bosch Access Easy Controller 2.1 - Page 107

Access Easy Controller 2.1 Appendix B Modem Setup | en 107
Robert Bosch (SEA) Pte Ltd Hardware Installation Manual 2018.11 | 1.0.6 | F.01U.122.796
1. Firstly set the GSM Modem as shown above, and then connect the GSM Modem to the PC
via the serial port and run HyperTerminal. Follow the steps below to send out a test SMS.
Type “AT+CMGS=xxxxxxxx” followed by a return, you will expect to see a “>” reply from
the GSM Modem. (xxxxxxxxx denote the mobile number).
2. Next type the message “TESTING TESTING” followed by <ctrl-Z> followed by a return, you
will expect to see a “+CMGS: nn” followed by a “OK”, this means the SMS is sent
successfully. (nn denote a double digit number provided by the GSM modem).
Notice!
Model supported by AEC2.1
Wavecom Fastrack Supreme 10 (Quad Band External GSM Modem)