Access Easy Controller 2.1 How to Install Reader and Field Devices | en 55
Robert Bosch (SEA) Pte Ltd Hardware Installation Manual 2018.11 | 1.0.6 | F.01U.122.796
The reader LED should then begin a slow alternating flash between red and green
indicating that the PIN code should be entered.
3. Enter the card's PIN code by slowly pressing the numeric keys on the reader's keypad.
After entering the last digit, press the # key to complete PIN entry.
Result: An audible beep will be heard after each key is pressed.
4. Depending on the setup of the controller database for the card used in the previous step,
one of two events will occur within a second after pressing the # key in the previous step.
Note that either response indicates that the reader and keypad are working.
– If the card is configured to allow access through the reader and the correct PIN code
was entered, then the LED will light in green for a few seconds indicating that access
has been granted.
– Or, if the database has not yet been fully configured, then the LED will flash rapidly
in an alternating pattern between red & green for two of three seconds indicating
that access has been denied.
To Next Page
Loading...
Need help?
General
