Bosch COOKIT MCC9555FWC - Cleaning the Pot; Cleaning the Tool Holder; Cleaning the Twin Whisk; Descaling the Pot

en Cleaning and servicing
122
20.7 Cleaning the twin whisk
1. Remove both beating whisks from
the twin whisk.
2. Carefully clean all parts under run-
ning water using a brush.
3. Dry all parts.
4. Position the beating whisks vertic-
ally on the pins and push in firmly.
The beating whisks must move
easily.
a The beating whisks engage aud-
ibly.
Tip:You can clean the twin whisk in
the dishwasher.
20.8 Cleaning the pot
Requirement:The tool has been re-
moved. →Page102
1. Clean the pot thoroughly.
2. Wipe down the pot with a soft,
damp cloth and then dry.
Note:If you are cleaning the pot in
the dishwasher, remove the tool
holder.
Tips
¡ You can clean the pot in the dish-
washer.
¡ You can remove light discoloura-
tion on the bottom of the pot with
water and a little vinegar.
→"Descaling the pot", Page122
20.9 Descaling the pot
Requirement:The first signs of
limescale are visible.
1. Take the pot out of the main unit.
2. Use a normal household descaler
in the pot according to the instruc-
tions.
3. Clean the pot with a dishwashing
brush or soft cloth.
4. Rinse the pot with plain water.
5. Dry the pot.
20.10 Cleaning the tool
holder
1. Remove the tool holder.
→Page120
2. Remove the silicone sealing ring
from the tool holder.
3. Clean the silicone sealing ring with
a soft cloth under running water.
4. Clean the tool holder with a brush
under running water.
5. Dry all parts.
6. Insert the tool holder with the silic-
one sealing ring.
7. Turn the pot on its side.
8. Tighten the threaded ring with
wings as far as it will go.
a The symbols and line up.
Tip:You can clean the tool holder
and the silicone sealing ring in the
dishwasher.