Bosch D1260 - Page 107

Part III: Advanced Commands
SERVICE MENU ? (9 + 9 + Enter)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
3. Enter the start date in
the form of mm/dd.
Ex: To enter 12/21
as the start
date, press 1 2
2 1
Once you start entering digits, the Print all events> soft key is replaced with the Enter> soft key.
Press either the Enter> soft key or the ENTER button.
4. If the date entered is
valid, the events for
that date will be sent to
a connected printer
and the display will
show Printing events.
for three seconds,
before returning to idle
text.
Using Display Rev
1. Press the Display Rev ?> soft key to display the current
software version of the panel.
2. The display will change to Radionics D9412* Version
6-40
(D9412 and 6-40 are used as an example, other panels
could be D9112, D7412, D7212)
3. The display will return to idle text after 5 seconds.
Using Service Walk Test
Note: The Service Walk Test function is only available in the Service Menu for D9412 and D9112 panels. If the panel
model is D7412 or D7212, the Service Walk Test will have to be enabled on the Function list for the command
center through the panel’s programming.
1. When the display shows ### points remain to be tested
you can begin. (### is the number of points)
Note: If you know the point number, you can enter it by pressing its number key and then the
ENTER key.
The display will change to show the point that was entered. If the point is invalid the message “Invalid Point” or
“This is not a valid walk point” appears.
Test each point by first opening and then closing the door or window or other detection device.
Check the display after testing each point. For interior points, walking past the device once is
sufficient. If any point does not test correctly, contact your security company for service.