Part II: System Commands
Turning On the System (Arming)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
Turning On the System (Arming)
Your security system can be turned on (armed) in many different ways, depending on the arming command used.
Arming Commands are those commands used to turn on the system. The most basic arming command is to arm the
entire system. The simplest way to arm your system is to enter your personal passcode or press [COMMAND] [1].
There are several other arming commands to turn on the system. These are described later in this manual.
To Turn Your Security System On (Arm):
1.
Enter your passcode and press ENTER.
2. The command center briefly displays AREA 1 NAME
TEXT is now arming…,
and the exit delay tone begins. After exit delay time
expires,
the display changes to idle armed text.
To Next Page
Loading...
