Bosch D1260 - Page 30

Part II: System Commands
MASTER ARM ? (COMMAND + 1)
D1260 Owner’s Manual
50410C © 2003 Bosch Security Systems
Master Arming all Areas
If you prefer, you may use the Master Arm ?> command in the Command Menu to initiate this function which will arm
all available areas according to your authority level.
1. The display shows disarmed idle text.
2.
Press the MENU> soft key to enter the Command
Menu,
3.
then press NEXT> soft key repeatedly
4. until you reach the MASTER ARM ?> prompt. Press
the soft key.
5. The display may prompt you to enter your passcode.
The passcode is shown as asterisks (*) when entered.
6. If there is more than one area that is set up, the option
is given to arm all of them with MASTER ARM ALL ?
or by pressing the Next> soft key…
to view each unarmed area and optionally arm each
one.
7.
To arm a selected area, press Next> until the desired
area appears (Area name text along with Arm Area #
?).
8.
Then press Arm>
9. The next available area will appear with the option to
arm it.
Every time the Next>,<Previous or Arm> soft keys
are pressed, the display scrolls to the next unarmed
area.
10.
To arm all available areas, press the Arm> soft key
when the display reads Master Arm All ?