Part II: System Commands
Special Alerts (COMMAND + 7 and COMMAND + 9)
D1260 Owner’s Manual
50410C © 2003 Bosch Security Systems
Using COMMAND 9:
1. Ensure your command center shows idle disarmed
text.
2.
Press the COMMAND key.
3. The display shows *System Command*.
4. Press the 9 key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the USER CMD 9 ?> prompt then press the
adjacent soft key.
5.
Your COMMAND 9 special alert has been programmed to:
notify your alarm company
ring a bell on your premises
display at your command center
Description:
To Next Page
Loading...
