Part III: Advanced Commands
CHG SKEDS ? (COMMAND + 5 + 2)
D1260 Owner’s Manual
50410C © 2003 Bosch Security Systems
6. If the Sked is currently enabled, the sked is shown with
Disable this sked> on the second line. Press the
adjacent soft key.
7. The display changes to show that the sked is disabled.
If the Sked is currently disabled, the display says Skd 1
is disabled.
Press the Enable this sked> soft key.
8. The display shows two soft keys:
• Only on holiday>
Pressing this soft key will enable the sked only on holidays and change the first line of the
display to Skd 1 X 08:00AM without the X.
• Except on holiday>
Pressing this soft key will disable the sked on holidays and change the first line of the display to
Skd 1 08:00am with the X.
Consult your security company and determine which holidays have been programmed in your
system.
9. The display changes to allow a new time to be entered.
Enter the new time using a 12-hour (HH:MM) format.
Ex: If the desired time is 8:00, press 8 + 0 + 0.
Press the Enter> soft key or the ENTER button.
10. If the time is a valid time, the command center display
changes to show the new time with a selection of AM
or PM.
Press the AM> soft key to select AM.
Press the PM> soft key to select PM.
11. The display shows the Sked with the new time.
Press the <Exit soft key to return to idle text.
To Next Page
Loading...
