Applications Manual FHP560 Controller | 37
Bosch Thermotechnology Corp.
Data subject to changePage____ of ____
14.3 ZS Sensor Dimensions
Fig. 7 ZS Sensor Dimensions
14.4 ZS Sensor Features
The FHP ZS Combo Sensors are thermistor-based, communicating temperature sensors that may optionally sense humidity or CO₂. The ZS
Sensors are fi eld installed and are wired to the Rnet port of the FHP560 controller. A maximum of 5 ZS sensors may be daisy-chained and used for
applications where multiple readings for temperature, humidity or CO₂ are required.
Features:
• Local access port
• No user control
Available in:
• Temperature only - 8733933902
• Temperature with Humidity - 8733933903
ZS Standard
Fig. 8 ZS Standard
Features:
• Slide potentiometer to make the zone warmer or cooler
• button to override the schedule and put the zone in an
occupied state, or force the zone to an unoccupied state
Available in:
• Temperature only - 8733933901
NOTE:
Slide the sensor’s potentiometer up to make the zone
warmer or down to make it cooler. The control program
determines how much you can adjust the setpoint.
ZS Plus
• Green LED to indicate occupied state
• Local access port
Slide
Fig. 9 ZS Plus
Features:
• LCD display
• button to override the schedule and put the zone in an
occupied state, or force the zone to an unoccupied state
Available in:
• Temperature only - 8733933898
ZS Pro
• and buttons to change any editable property, such as
the temperature or humidity setpoint.
• button to cycle through information defined in the
control program.
• Green LED to indicate occupied state
• Local access port
• Temperature with Humidity - 8733933899
• Temperature with Humidity and CO₂ - 8733933900
Fig. 10 ZS Pro
To Next Page
Loading...
