-8-
Additional Safety Rules
THINK SAFETY
SAFETY IS A COMBINATION OF OPERATOR COM-
MON SENSE AND ALERTNESS AT ALL TIMES WHEN
THE TABLE SAW IS BEING USED.
GFCI and personal protection devices like electri-
cian’s rubber gloves and footwear will further en-
hance your personal safety.
Do not use AC only rated tools with a DC power
supply. While the tool may appear to work, the
electrical components of the AC rated tool are like-
ly to fail and create a hazard to the operator.
Develop a periodic maintenance schedule for your
tool. When cleaning a tool be careful not to disas-
semble any portion of the tool since internal wires
may be misplaced or pinched or safety guard return
springs may be improperly mounted. Certain clean-
ing agents such as gasoline, carbon tetrachloride,
ammonia, etc. may damage plastic parts.
Wear Eye Protection
WARNING
The operation of any power
tool can result in foreign ob-
jects being thrown into the
eyes, which can result in se-
vere eye damage. Always wear
safety goggles that comply with
ANSI Z87.1 (shown on pack-
age) before commencing power tool operation.
Some dust created by power
sanding, sawing, grinding,
drilling, and other construction activities con-
tains chemicals known to cause cancer, birth de-
fects or other reproductive harm. Some examples
of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are spe-
cially designed to lter out microscopic particles.
Before each use, review all warnings
located on the table saw.
Intended Use
Use this table saw only as in-
tended. Unintended use may
result in personal injury and property damage.
This table saw is intended for rip, cross, miter,
bevel and non-through cut applications in various
wood and plastic materials.
Table top CLAMPZONE™ locations are intended for
securing workpieces to the table top with light duty
work clamps while performing light-duty nishing
applications such as sanding, coping, or routing.
Do not use this table saw for cutting metals, such
as aluminum or copper, or any masonry or cement
materials.
Do not use wobble or adjustable dado sets with
this table saw.
If cutting plastic, make sure the feed rate is slow
enough and blade tips are sharp enough to avoid
melting the plastic.
Do not use molding head cutters with this table
saw.
Do not perform tapered cuts without a tapered jig
accessory.
SAVE THESE INSTRUCTIONS
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 81609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 8 4/20/2023 11:23:01 AM4/20/2023 11:23:01 AM
To Next Page
Loading...
