Bosch GTS15-10 - Tools Needed For Assembly

-16-
Tools Needed For Assembly
Combination square must be true.
Draw light
line on
board along
this edge.
Straight edge of
board 3/4” (19
mm) thick. This
edge must be
perfectly straight.
There should be no gap or
overlap here when square is
ipped over in dotted position.
Fig. 6
Combination Square
8 mm open-ended wrench
Flat screwdriver
Phillips screwdriver
Fig. 5
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 161609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 16 4/20/2023 11:23:10 AM4/20/2023 11:23:10 AM