Bosch GTS15-10 - Mounting the Table Saw

-30-
Storage, Transportation, and Mounting
Mounting the Table Saw
(Fig. 35, Fig. 36)
To prevent personal injury, al-
ways disconnect plug from
power source before performing any assembly,
adjustment, or repair.
To prevent movement while cutting, the table saw
must be fastened securely to a stand or workbench,
using the four Mounting Holes 34.
If mounting the saw to a workbench, the Base 5
should be secured using four 3″ (77 mm) long
screws (not included) through the Mounting Holes
34. Make sure the screws extend through the saw’s
frame and securely attach into the supporting work
surface.
front
front
of saw
of saw
34
34
34
34
5
34
34
Fig. 35
rear
rear
of saw
of saw
34
34
34
34
Fig. 36
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 301609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 30 4/20/2023 11:23:29 AM4/20/2023 11:23:29 AM