Bosch GTS15-10 - Attaching the Rip Fence

-21-
Attaching the Rip Fence
(Fig. 20, Fig. 21, Fig. 22, Fig. 23, Fig. 24)
1. Make sure that the Rail Lock Lever 6 is in the
locked position.
2. Lift the Rip Fence Lock Levers 55 up on both
ends of the Rip Fence 9 so that they are in the
released position .
3. Orient the Rip Fence 9 over one of the three
Rip Fence Index Pin pairs, 56, 57, or 58, so that
the Flip-Over Fence 17, in its stored position,
is facing away from the Blade 31 and the Smart
Guard System 11.
NOTE: For how to put the Flip-Over Fence 17
in its stored position, see “Rip Fence Storage”
on page 25.
4. Lower the Rip Fence 9 to the Rails 10 so that
the notches on the Rip Fence bracket 59 line up
with the Rip Fence Index Pin pair that you have
selected, 56, 57, or 58, and lower the Rip Fence
9 onto the Index Pin pair .
5. Latch the Rip Fence Lock Levers 55 on both
ends of the Rip Fence 9 .
Assembly
A
55
55
55
55
A
9
C
C
55
55
55
55
9
Fig. 20
50
50
31
31
A
Fig. 17
28
52
52
51
51
31
31
53
53
B
C
Fig. 18
51
52
54
53
Fig. 19
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 211609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 21 4/20/2023 11:23:18 AM4/20/2023 11:23:18 AM