Bosch GTS15-10 - Basic Table Saw Operations; Power Switch; Using the Smart Guard System

-39-
Power Switch
(Fig. 53, Fig. 54)
To turn saw on: flip the Clear Switch Cover 92 up,
and press the Green ON (I) Button 93.
To turn the saw off: push the Red OFF (0) Stop
Paddle 94.
To prevent unauthorized use, the Power Switch 1
can accommodate a padlock with a 1/4” (6.3 mm)
diameter shackle (not provided with the table saw).
Lock the switch as follows:
1. Flip the Clear Switch Cover 92 down.
2. Press the Clear Switch Cover 92 and Red Stop
Paddle 94 to align the holes.
3. Secure the switch with a padlock thru both
sides of the switch. Padlock (not provided with
the saw) must have a 3/16″ or 1/4″ (4.5 or 6
mm) diameter shackle.
Using the Smart Guard System
(Fig. 55)
The Bosch Smart Guard System 11 has been de-
signed for modularity, enabling the use of multiple
combinations of the three main components: the
Riving Knife 25, the Barrier Guard Assembly 26,
and the Anti-Kickback Device 27.
The Riving Knife 25 can be quickly adjusted to
any of three positions for different applications:
through cut (high), non-through cut (middle), and
dado (lowest).
The three primary components of the Smart Guard
blade guarding system are designed for rapid at-
tachment, adjustment, and removal without addi-
tional tools.
If you remove any Smart Guard System 11 compo-
nents to complete a cut, immediately reinstall them
when nished. (See “Attaching the Barrier Guard
Assembly” on page 19 for detailed installation
instructions.)
Always remember that the best accident prevention
is the operator’s use of common sense and alert-
ness at all times when using the table saw.
Basic Table Saw Operations
To prevent personal injury, always disconnect plug from power source before per-
forming any assembly, adjustment, or repair.
Fig. 54
93
93
92
92
Fig. 53
94
94
25
25
26
26
27
27
12
12
13
13
11
Fig. 55
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 391609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 39 4/20/2023 11:23:42 AM4/20/2023 11:23:42 AM