-11-
Symbols
IMPORTANT: Some of the following symbols may be used on your tool. Please study them and learn
their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer.
Symbol Designation/Explanation
V Volts (voltage)
A Amperes (current)
Hz Hertz (frequency, cycles per second)
kg Kilograms (weight)
min Minutes (time)
s Seconds (time)
⌀ Diameter (size of drill bits, grinding wheels, etc.)
n
0
No load speed (rotational speed, at no load)
.../min
Revolutions or reciprocation per minute (revolutions, strokes, surface speed, orbits
etc. per minute)
Class II construction (designates Double Insulated Construction tools)
Alternating current (type or a characteristic of current)
Alerts user to read manual.
Alerts user to wear eye protection.
This symbol designates that this tool is listed by Underwriters Laboratories, to United
States and Canadian Standards.
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 111609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 11 4/20/2023 11:23:03 AM4/20/2023 11:23:03 AM
To Next Page
Loading...
