Bosch GTS15-10 - Adjusting 45° Positive Stop

-38-
Adjusting 45° Positive Stop
(Fig. 49, Fig. 51, Fig. 52)
1. Turn the Elevation Wheel 2 clockwise and raise
the Blade 31 to maxi mum height.
2. Loosen the Blade Bevel Lock Handle 3 by turn-
ing it counterclockwise.
3. Push the Elevation Wheel 2 to the right as far
as possible. Then tighten the Blade Bevel Lock
Handle 3 by turning it clockwise.
4. Place a combination square on the Table 13
with one end of the square against the Blade
31, and check to see if the Blade 31 is 45° to
the Table 13.
5. If the Blade 31 is not 45° to the Table 13:
• Loosen the Blade Bevel Lock Handle 3 by turn-
ing it counterclockwise.
• Loosen the Jam Nut on the 45° Bevel Stop
Bolt 89 with an 8 mm open end wrench and
rotate the 45° Bevel Stop Bolt 90 until there
is enough clearance to set the Blade 31 at 45°
without contacting the Stop.
• Push the Elevation Wheel 2 until the Blade 31
is 45° to the Table 13.
6. Tighten the Blade Bevel Lock Handle 3 by turn-
ing it clockwise.
7. Rotate the 45° Bevel Stop Bolt 90 until it touch-
es the Bevel Stop Housing, then tighten the Jam
Nut 89, making sure that the 45° Bevel Override
Stop 91 stays in position.
4. Place a combination square on the Table 13
with one end of the square against the Blade
31, and check to see if the blade is 90° to the
Table 13.
5. If the Blade 31 is not 90° to the Table 13:
• Loosen the Blade Bevel Lock Handle 3 by turn-
ing it counterclockwise.
• Loosen the Jam Nut on the 0° Bevel Stop Bolt
84 with an 8 mm open end wrench and rotate
the 0° Bevel Stop Bolt 85 until there is enough
clearance to set the Blade 13 at 0° without
contacting the Stop.
• Push the Elevation Wheel 2 until the Blade 31
is 90° to the Table 13.
6. Tighten the Blade Bevel Lock Handle 3 by turn-
ing it clockwise.
7. Rotate the 0° Bevel Stop Bolt 85 until it touches
the Bevel Stop Housing, then tighten the Jam
Nut 84, making sure that the 0° Bevel Override
Stop 86 stays in position.
8. Loosen the Bevel Indicator Adjustment Screw
87
87, and adjust the Bevel Pointer 88 to indicate
0° on the Blade Bevel Scale 4.
Adjustments
31
31
13
13
Fig. 52
89
89
90
90
91
91
Fig. 51
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 381609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 38 4/20/2023 11:23:40 AM4/20/2023 11:23:40 AM