66 en | Diagnostics Panel Controller
2017.09 | 7.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
3. Ethernet ports
Information on Ethernet port 1 is displayed.
You can use the arrow key on the display to switch to details of Ethernet port 2.
To update the information displayed, select Refresh.
Information on the following parameters is displayed in the table:
– Port status
– Link status: Checks the operativeness of the network cable
– Speed: Speed of the network connection
– #Tx Frames: Number of transferred data packages
– #Rx Frames: Number of received data packages
– Connected to: Indicates neighboring available node
14.7.4 Send ping command
To check the availability of other nodes in the network, a ping command can be sent to a
specific IP address:
1. In the start menu, select Diagnostics
2. Network services
3. Send ping command
4. Enter the IP address of the network node you wish to assess as regards availability and
select Send ping command.
To enter an IP address:
Touch the field containing the IP address. Use the arrow keys on the operating panel to
select the individual numbers and modify using the number keys on the alphanumeric
keypad.
Or:
Touch the Change field. Touch the field containing the number block to be changed. Use
the arrow keys on the operating panel to select the desired number and modify using the
number keys on the alphanumeric keypad.
If the addressed network node is accessible, a success message is displayed.
14.7.5 Ethernet redundancy
To display a list with details of the redundancy mode, RSTP parameters the root bridge and
local bridge, as well as information on the two Ethernet ports:
1. In the start menu, select Diagnostics
2. Network services
3. Ethernet redundancy
A list with details of the following is displayed:
– Redundancy mode
– Root bridge/ local bridge:
– Priority
– MAC address
– Hello time
– Max. age
– Forward delay
– Ethernet 1/Ethernet 2 port:
– Port role
– Port status
To Next Page
Loading...
Need help?
General
