78 en | Maintenance – history log Panel Controller
2017.09 | 7.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
17.3 Change Filter
On each filter menu, another filter can be set using the status bar:
1. Select Change filter from the selection bar below.
The various filters are displayed.
2. Select one of the filters displayed.
A list with filtered data is displayed.
17.4 Combining several filters
It is possible to set several filters and to display all filtered data in a list:
To combine the Device types filter with the Message types filter:
1. Select Maintenance from the start menu
2. History Log
3. Select a filter, e.g. Device types.
4. Select Change filter in the selection list.
5. Select the desired device types from the displayed list.
6. Repeat steps 4 to 5 until all desired filters have been selected.
To display all filtered data of the combined filters:
7. Select Show filter result.
17.5 Status bar functions
The following functions are offered:
To switch to the status bar on the start page, press the "double
arrow" key in the status bar or on the membrane keypad.
Change filter If the field has a black background, a filter has been set. Select
this field to set a different filter.
Go to no. Enter the number of a specific event.
The event with the selected number is displayed at the start of
the list.
Go to day Enter a date.
All events with the selected date are displayed in the list.
Print Print the complete displayed list or only a part of it.
Exit End the entry and switch to the menu overview for the
Maintenance menu.
To Next Page
Loading...
