Panel Controller Further functions | en 91
Bosch Sicherheitssysteme GmbH User Guide 2017.09 | 7.0 | F.01U.258.929
– To unblock the service select Unblock Remote Maintenance.
Notice!
The Blocking/Unblocking of Remote Maintenanceis done for all panels in the network. You
cannot block/unblock this service for a single panel.
Remote Alert
To stop the transmission of Remote Alert messages:
– In the start menu, select Further functions
– Remote Services
– Select Block Remote Alert.
The transmission of messages to the Remote Portal is stopped until the next restart of
the panel controller.
– To unblock the service select Unblock Remote Alert.
Notice!
The Blocking/Unblocking of Remote Alert is done for all panels in the network. You cannot
block/unblock this service for a single panel.
20.5 Change password
Notice!
If all operators with the same access authorization have the same password, this function
cannot be used.
1. In the start menu, select Further functions
2. Change password
A list of all operators is displayed.
Refer to Scrolling through lists, page 27 for information on how to navigate through a list.
3. Select the list field you require.
4. Enter the password.
On the display, each digit of the password is indicated with an asterisk so that nobody
else can see the password.
5. Enter a new password and repeat the entry in the bottom field again.
6. Select OK to confirm the entry or Cancel to cancel the operation.
20.6 Performing a fire drill
During a drill, all signaling devices are activated.
Caution!
If a genuine alarm is reported during a fire drill, the fire drill is abandoned. The fire drill can
only be restarted when the alarm is ended.
To start a drill:
1. In the start menu, select Further functions
2. Drill
3. Confirm Start drill with OK
The drill is started.
To end the drill, select Stop drill.
To Next Page
Loading...
Need help?
General
