ctrlX SAFETY | Safety instructions 11/83
DOK-XSAFE*-SAFEX-C.1XC-IT03-EN-P, Edition 03, Bosch Rexroth AG
Improper use of the product includes, for example:
• Applications for which ATEX certification is necessary,
• Applications for which approval by classification societies is required,
or
• Applications in countries for which a national certificate not yet issued for the product is
required.
2.4 Qualification of personnel
The activities described in this documentation require basic knowledge of mechanical and
electrical systems, as well as knowledge of the associated technical terms. In order to
ensure safe use, these activities may therefore only be carried out by an appropriate
specialist or a trained person under the direction of a specialist.
Specialists are persons who, based on their professional training, their knowledge and
experience, as well as their knowledge of the relevant regulations, can assess the work
assigned to them, identify potential risks and take appropriate safety measures. Specialists
must always comply with the relevant technical rules.
2.5 General safety instructions
WARNING
Non-observance of the general safety instructions
Damage to the product and the environment
Observe the applicable regulations for accident prevention and environmental protection.
Observe the safety regulations and the regulations of the country in which the product is
used/applied.
Use Rexroth products only in technically perfect condition.
Observe all instructions on the product.
Persons who install, operate, dismantle or maintain Rexroth products must not be under
the influence of alcohol, other drugs or medications that affect their reaction capacity.
Only use accessories and spare parts approved by the manufacturer in order to
eliminate risks to personnel due to unsuitable spare parts.
Comply with the technical data and ambient conditions specified in the product
documentation.
If unsuitable products are installed or used in safety-related applications, unintended
operating conditions can occur in the application, which can cause personal injury
and/or property damage. Therefore, only use products in safety-related applications if
such use is expressly specified and permitted in the product documentation.
It is only allowed to commission the product after it is established that the final product
(e.g. a machine or a system) in which Rexroth products are installed complies with the
country-specific regulations, safety rules and application standards.
To Next Page
Loading...
