Bosch Rexroth ID 40/SLK-CAN - Page 7

7/176
3 842 530 344/2014-05, MIT: ID 40, Bosch Rexroth AG
11.3.3 Showing CANopen status on the display 157
11.3.4 Configuring the second SDO channel 158
11.4 Adjusting the baud rate of the serial interface 158
12 Diagnostics 159
12.1 Troubleshooting guide 159
12.1.1 Important information that can indicate errors 159
12.1.2 Fatal system errors 159
12.1.3 Diagram of possible causes of errors 161
12.2 Diagnostics using the web interface 162
12.3 SLK software upgrade via serial interface 162
13 Technical data 163
13.1 Cables, connector pin assignments 164
13.2 SLK nameplate 165
13.3 Data transmission times between MDT and controller 166
13.3.1 Transmission times with Profibus 166
13.4 Compatibility 167
13.4.1 Compatibility with older software versions 167
13.4.2 Compatibility with ID 80/E and MTS 2 167
14 Overview for ordering ID 40 modules 168
15 Service and support 170
15.1 Technical support 170
15.2 Internet 170
15.3 Site 170
16 Appendix 171
16.1 ID 40 system link model 171
16.2 Abbreviations and terms 173
16.3 References 175
PROOF COPY 1 | 20.05.2014 | FOR INTERNAL USE ONLY
ENGLISH