Boss MD500 - Page 11

11
Parameter List
Parameter Value Explanation
CE-1 CHORUS, CE-1 VIBRATO
RATE 0.01–20.00 Hz Adjusts the rate of the chorus.
BPM 6.0–600.0
Species the tempo.
The range of this setting depends on the RATE or NOTE value.
NOTE
`
–
Œ
Adjusts the rate of the chorus, specied as a note value relative to BPM.
DEPTH 0–100 Adjusts the depth of the chorus.
LOW LEVEL -50–+50 Adjusts the low frequency range tone.
LOW FREQ 20.0–800 Hz Species the frequency adjusted by the LOW LEVEL setting.
HIGH LEVEL -50–+50 Adjusts the high frequency range tone.
HIGH FREQ 630–16.0 kHz Species the frequency adjusted by the HIGH LEVEL setting.
PREAMP SW OFF, ON Species whether the CE-1’s preamp is simulated (ON) or not simulated (OFF).
PREAMP GAIN 1–100 Adjusts the gain of the preamp. Higher settings will produce distortion.
PREAMP LEVEL 0–100 Adjusts the volume of the preamp.
OUTPUT MODE
Species the output of the chorus.
MONO Mono output.
STEREO
Direct sound is output from the OUTPUT A/MONO jack, and eect sound is
output from the B jack.
TRI-CHO
RATE (*1) 0.01–20.00 Hz Adjusts the rate of the chorus.
BPM (*1) 6.0–600.0
Species the tempo.
The range of this setting depends on the RATE or NOTE value.
NOTE (*1)
`
–
Œ
Adjusts the rate of the chorus, specied as a note value relative to BPM.
LFO MODE
Selects the LFO mode.
PRESET The RATE is xed (4.98 Hz).
MANUAL RATE adjusts the rate of the chorus.
P+M The PRESET and MANUAL LFOs are summed.
INTENSITY1 (*2) 0–100
Adjust the depth of the three-phase chorus.INTENSITY2 (*2) 0–100
INTENSITY3 (*2) 0–100
BRIGHT OFF, ON
Species whether the high-frequency region of the eect sound is boosted (ON)
or not boosted (OFF).
LOW LEVEL -50–+50 Adjusts the low frequency range tone.
LOW FREQ 20.0–800 Hz Species the frequency adjusted by the LOW LEVEL setting.
HIGH LEVEL -50–+50 Adjusts the high frequency range tone.
HIGH FREQ 630–16.0 kHz Species the frequency adjusted by the HIGH LEVEL setting.
OUTPUT MODE MONO, STEREO Species whether the output is mono (MONO) or stereo (STEREO).
*1: Unavailable if LFO MODE is “PRESET”
*2: Shown if LFO MODE is “MANUAL” or “P+M”