Boss MD500 - Bank, System, and MIDI Configuration

20
Parameter List
BANK
You can specify how patches A and B are connected and output when using simul mode.
5 “Using Two Patches Simultaneously (Simul Mode)” (p. 23)
SYSTEM
Parameter Value Explanation
CONTRAST 1–16 Adjusting the contrast of the display
INSERT LOOP OFF, ON Species whether the insert loop function (p. 24) is used (ON) or not used (OFF).
BANK MODE
Species the timing at which the patch is changed when you change banks.
WAIT
Switching the bank only changes the indication of the screen, and does not
switch the patch at that point. When you press the [A] or [B] switch, the bank
and number are nalized, and operation switches to the next patch.
IMMEDIATE Operation immediately switches to the next patch when you switch banks.
BANK EXTENT MIN 01–99 Sets the lower limit for the banks.
BANK EXTENT MAX 01–99 Sets the upper limit for the banks.
KNOB LOCK OFF, ON Species whether knob operations are disabled (ON) or not disabled (OFF).
KNOB MODE IMMEDIATE, HOOK
When you move a knob, this setting species whether control data for that
knob position is always output (IMMEDIATE) or is output only after the knob
position has passed through the current value of the parameter (HOOK).
BYPASS BUFFERED, TRUE Species how the bypass sound is output (buered bypass or true bypass).
PEDAL ACT PUSH, RELEASE
Species whether the operation occurs when you press the [A], [B], or [TAP/CTL]
switch or when you release the switch.
FSW MODE Species how the footswitch is used (p. 22).
USB MODE Species the USB operating mode (p. 27).
MIDI
Parameter Value Explanation
Rx CHANNEL Ch.1–16, OFF
Species the receive channel.
If this is “OFF,” MIDI messages are not received.
Tx CHANNEL Ch.1–16, Rx, OFF
Species the transmit channel.
If this is “OFF,” MIDI messages are not transmitted.
PC IN OFF, ON Species whether program changes are received.
PC OUT OFF, ON Species whether program changes are transmitted.
BANK SEL OUT MSB, M+L
Species the bank select message that is transmitted simultaneously with the
program change.
If you select MSB, only MSB (CC#0) is transmitted. If you select M+L, both MSB
and LSB (CC#32) are transmitted.
CC IN OFF, ON Species whether control changes are received.
CC OUT OFF, ON Species whether control changes are transmitted.