Multi-DM™ User Manual Section 9 - DMShapes Software Overview
BMC Document Number: DOC-0009 Rev. 5.2 Page 33
The DMShapes Toolbar (continued)
Icon Label Description
Poke
Previous
Press to apply the value of the current actuator to the actuator one
lower in number, i.e. poke it. The poked actuator then becomes the
current selection. The values of the original actuator and the other
non-poked actuators after the poke depend upon the starting state as
follows:
• If the actuators have been set to a single value by the piston or by
the Zero button, with or without any individual actuator values
manually changed, after the poke all other actuators, including the
previously selected one and any that had been changed from the
Piston or Zero value, are returned to the Piston value.
• If a Command Map has been applied, with or without any individual
actuator values manually changed, after the poke all other
actuators including the previously selected one are set to the
current Piston value (0.25).
If the lowest (0) actuator is selected, the next one will wrap
to the highest numbered actuator.
Note this command does not update the Poke Actuator and Poke
Value in the Status bar.
As this command changes the value of an actuator to the value of an
adjacent actuator, it has no effect on that actuator if the adjacent
actuator had the same value. It may however change the values of the
original and other actuators.
Poke Next Same as Poke Previous except in the opposite direction, i.e. applies
the value of the current actuator to the actuator one higher in number.
If the highest actuator is selected, the next one will wrap
to the lowest (0) numbered actuator.
Zero Sets all actuators to 0.
To Next Page
Loading...