Bowers M1 - DATA EXPORT ON USB KEYS; Standard mode

M1 – M3 Display units
Page 71
10. DATA EXPORT ON USB KEYS
The M1 and M3 offer various possibilities for data export.
From the software version 2.1 new functionalities have been added offering the
possibility to export with advanced functions to USB keys or network.
The M1/M3 are compatible with most of the available USB key.
However, some particular models are not compatible. It is also not compatible with
USB stick having a partition.
For saving the data on the USB key, you must configure the menu CONFIGURATION
 COMMUNICATION  USB Key
Then, when the transfer is triggered (by footswitch, touch of the PRINT button, by an
input action or Modbus), a file will be created on the USB key.
10.1. Standard mode :
As a standard a file named “output.csv” is created on the USB key. It look likes this :
Output.csv :
Characteristic
1
2
COMMENT
Name
P1 : C(1)
P2 : C(2)
Name of the characteristics (PART x –
CHANNEL x)
Upper tol.
+0.02100
-0.00700
Upper tolerance
Nominal
+20.00000
+20.00000
Nominal value
Lower tol.
+0.00000
-0.02000
Lower tolerance
Measure
+20.00012
+19.99350
GO
Data #1 + indication GO
Measure
+20.00011
+19.99340
GO
Data #2 + indication GO
Measure
+20.00010
+19.99980
NG
Data #3 + indication NG