Branson B Series - Page 94

B Series Degreaser Maintenance
Rev G Page 100
5.10.3 Defrost Controller Programming
Do not program the controller during defrost.
• Press the ។ and ៓ buttons simultaneously for 4 seconds. “PA” will be displayed.
• Press SET
• Press ។ or ៓ until –19 is displayed (This is the password).
• Press SET
• Press ។ and ៓ buttons simultaneously for 4 seconds. SP will be displayed.
• Press ។ or ៓ to show the desired parameter. (See Table 5-1 for available
parameters.)
• Press SET
• Press ។ or ៓ to change the value.
• Press SET