BREWART BEERDROID - Before Use: Preparation and Sanitisation; Equipment Preparation and Sanitisation; Sanitisation Procedure Details

BREWART BY COOPERS
12
Before Use
 Did you know?
The number one cause of brew
failure is infection. Sanitising your
BrewArt equipment is a vital part
of successful brewing.
Prepare and sanitise
your equipment
 WARNING
DO NOT tilt or lay BeerDroid on
its back or side as this can cause
damage to the compressor.
k Position near a sink or
somewhere you can drain the
contents of your BeerDroid.
k Thoroughly rinse the inside of
the BeerDroid, the lid, drain plug
and tap (pulling tap apart).
k Assemble the tap and insert
the tap and drain plug into the
BeerDroid – see Diagram E.
 Note
To install your tap and drain plug,
you should lubricate the rubber
seal before inserting into the
BeerDroid. This can be done with a
small amount of olive oil.
k Fill your BrewArt BeerDroid
with warm water to within
5mm of the brim.
k Add BrewArt sanitising tablet.
k Fasten the lid into the lock
position – see Diagram F.
 Note
The lid may be tight for the first
few uses, if so, lubricate the face
of the seal with a small amount of
olive oil.
k Leave for one hour.
k Open the tap and release half a
cup of liquid through the tap.
k Leave for a further hour.
k Drain the water through the tap
until no more water flows out.
k Remove drain plug and allow the
remaining water to flow out.
k Lightly rinse with clean water.