19
Keg
The Keg Zone brings your brew to
optimum temperature for kegging or
bottling, this is pre-set to 18°C (64°F) for
and programs. In a
program it will be the temperature you
set manually.
k The display screen will
indicate .
k The display screen will read:
, .
When the brew is within 1°C
(2°F) of this target temperature,
it will read: .
k The temperature displayed
on the screen indicates the
current brew temperature
k When your BeerDroid indicates
,
on the control panel.
This will end the current program.
k Turn unit o at the rear
power switch.
k Keg or bottle your beer.
Note
Before Kegging or Bottling we
recommend pouring a small
amount of brew (100ml or
less) into a glass through the
tap. Smell and taste the brew
sample to ensure brew quality.
End of Fermentation
(EOF) not detected
If has not been detected during the
ferment zone then:
k will appear
on the display screen, and
k
in the user prompt panel.
End of fermentation will need to be
tested manually with a hydrometer over
two consecutive days to determine
if fermentation is complete – go to
brewart.com/101 for information on
how to use a hydrometer when EOF is
not detected.
If no action is taken within 2 days in the
zone the unit will automatically
move to the zone. Your brew can
safely stay in the zone until you
are ready to keg.
Note
If your BeerDroid is configured
for Wi-Fi operation, you may
transition between the
zone and the zone at any
time by using the BrewArt app.
Note
If you have manually transitioned
the unit from to , it
will not automatically transition
to again.
To Next Page
Loading...