BREWART BEERDROID - Kegging Equipment: Cleaning and Assembly; Clean and Sanitise Kegging Parts; Assembly of Valves

BREWART BY COOPERS
22
Clean & Sanitise
the following
keggingequipment
k Keg Liner Connector (C)
k Keg Filling Cap (F)
k Keg Filling Tube & Connectors (E)
k Keg Dispensing Cap (I)
 Note
The Dispensing Cap and
Orange Beer Valve should be
disassembled for cleaning and
sanitisation, see exploded view.
The black air valve does not
require disassembly and cleaning.
Ensure black air valve is done up
finger tight.
Take care not to lose small items
when cleaning and sanitising.
 Note
The orange o-ring must be fitted
in the orange valve head.
The white o-ring must be fitted
in the black valve head.
The springs and poppets
are interchangeable.
Assembly of valves
k Fit the Valve O-ring into
the Valve Head.
k Insert the Valve Spring
into the Valve Poppet.
k Insert the Valve Poppet and
Spring into the Valve O-ring.
k Screw the valve assembly into the
Dispensing Cap Housing as shown.
 Note
Do not over tighten. Finger tight is
suicient.