BREWART BEERDROID - Option 2 - WPS Setup; Before You Start; Part 1 - on Your Beerdroid; Part 2 - on Your Wi-Fi Modem

BREWART BY COOPERS
34
Option 2 – WPS Setup
Before you start
Make sure that your Wi-Fi modem (or
access point) supports WPS. Consult
its user manual.
If WPS is supported, confirm that WPS
is enabled (or turned on). Consult the
user manual to see if it is enabled
by default, if not, log in to the Wi-Fi
modem and enable it.
Part 1 – On your BeerDroid
a. Use the

and

arrows on
the control panel to scroll to
Wi-Fi in the main menu.
b. 
   will appear
on the user prompt panel.
c. Press

on the control panel to
enter the Wi-Fi configuration menu.
d. Navigate to  .
e. Press

to start setup.
f. Wait for the icon to start
flashing, then proceed to
Part 2 immediately!
Part 2 – On your
Wi-Fi modem
Press its WPS button (some devices
require you to press and hold the button
for a few seconds), then proceed to Part 3.
Part 3 – On your BeerDroid
Wait for the

icon to stop flashing
indicating that configuration is complete.
This could take up to 3 minutes.
If the configuration is successful, your
BeerDroid display screen will return
to the main menu and the

and
w
icons will initially appear o. Aer
a few seconds the

and
w
icons
will turn on aer it has successfully
connected to the Wi-Fi network and
contacted the BrewArt Server.
If the configuration failed, your
BeerDroid will display an  error code
and flash  . An additional
error code 
d  may appear. Refer to
the error code section for a list of errors.
Press

on the control panel to resume
or return to the main menu.
 Note
To use, monitor and control
your BeerDroid with the
BrewArt App you must link
your BeerDroid to your BrewArt
Account – see Appendix B –
Linking your BeerDroid.